Radial Engineering is now shipping the LX-2 passive line splitter. The Radial LX-2 allows users to send a single source to two different destinations at once without noise, with the ability to attenuate the input signal and tame hot outputs from a mixing console or mic preamp.
The input of the LX-2 features an XLR/TRS combo jack, which allows you to connect balanced or unbalanced line level signals to be split to two different destinations. A premium Jensen transformer inside provides frequency response and phase coherency to ensure audio quality is maintained, while isolating the two outputs from each other to eliminate hum and buzz from ground loops. Ground lift switches on each of the two XLR outputs help to further reduce ground loop noise. For situations where a level adjustment is required, the trim control on the LX-2 allows you to attenuate overly hot signals. This lets you drive the mic preamps hard to achieve colouration, while trimming the level at the LX-2 to avoid clipping the inputs of the recording interface. This trim control is activated by a recessed ‘set & forget’ switch for live use or, in situations where attenuation is not needed.
The LX-2 is built with 14-gauge steel, with a book-end design to protect the connections and switches. Rigid I-beam construction prevents torque from being applied to the circuit board, eliminating the possibility of damaging solder joints. The LX-2 has a compact footprint, with the added benefit of allowing up to eight units to be rack-mounted using the Radial J-Rak.
RRP is $219.99
ADVERTISEMENT
